We recently installed a new flexible fabrication system for Imperial Brown for their Tuscon, Arizona facility to process walk-in coolers and freezers. The system can handle 10,000 lb. coils of CRS, bottom side surface-critical up to 48” wide and ranging in thickness from 0.012” to 0.060”.

The system includes a 10,000 lb. motorized stock reel and combination upender / coil car to load eye-to-the sky coils and reposition them to load onto the mandrel of the uncoiler.

A vinyl applicator is mounted to the entry side of the CTL unit to apply vinyl to the bottom surface of the material before it is run through the straightener and edge trimmers. The 4-roll straightener removes coilset from the strip and has individually adjusted upper straightener rolls. The unit includes 2 edge trimmer blades that can be manually adjusted on the arbor to the desired distance. An edge trim rewinder is included on the back side of the CTL to collect and remove the edge trim scrap.

The beading roll embosses ridges into the sheet after straightening for rigidity of the finished product. A Dual Head Notcher includes 2 manually-adjusted “C” frame heads, each with a turret die to add a notch to each edge of the material. The notch is used to remove enough material to allow folding or forming of the part without the material buckling.

The roll former is used to form side flanges of the part, bending each side of the strip upward in a 90° bend. The roll former tooling is manually adjusted via a hand crank and ball screw assembly to be able to process material widths from 12” to 50”. A hydraulic cutoff shear is positioned at the exit of the roll former.

The line was installed by our Formtek-Maine Service Department and is now running. This is the second system Imperial Brown has purchased from us with a third system in process to be purchased now.






We recently installed a new 48” wide x 14 ga. SLEAR-2 unit in a customer’s existing Iowa Precision Multi-Blanking line. Oneto Metal Products is a Sacramento, California based fabricated sheet metal supplier providing various types of steel, copper, and aluminum to customers for commercial and industrial metal building products. The customer was looking to replace their existing SLEAR unit but with features to improve efficiency and produce a better quality and more accurate finished blank.

The unit is equipped with an IPI peeler table for hands-free thread-up of coils to peel the leading edge from the coil and support the strip from the uncoiler to the entry pinch rolls of the slear.

Our SLR4814-2-CT-150 has (6) pairs of slitter blades to produce up to (7) mults. Our slitter blade access door feature allows quick and easy operator access to the slitter arbors to add or remove knife pairs. The slitter knife precision indicator provides a digital readout to ensure proper blade positioning during setup.

The powered (6) roll straightener has offset rolls to remove coilset from material payed off the top or bottom of the coil. Each roll is individually adjustable.

The Slear includes a flying shear, which performs the cut “on the fly” while the material is in motion. This eliminates material marking as the strip never stops in the straightener. Because the material is always in motion, you can run at line speeds up to 150 fpm to produce more parts per minute than a standard start/stop line. The flying shear also eliminates the need for a looping pit in the floor.

The control includes our Close Tolerance package to improve the accuracy of cut parts. The flying shear is driven by a servo motor operating in closed loop mode to better synchronize the shear head to the movement of the material through the Slear.

This line has been installed and is currently in daily production.